Bar Stool Cover

I have this amazing bar stool in my craft room that my late Grandma Mimi painted but it isn't comfortable so I have been playing with the idea of making a cover or cushion for it. After a quick search on Pinterest to see if there was a tutorial for what I wanted I realized that I was just going to have to wing it using this tutorial from Camp Clem as a rough guide.

To start I measured top of the stool, at the widest part measured 13 inches. I then set out to make the "cushion", the cushion is actually 9 layers of Poly-Fil Traditional® Quilt Batting. I would suggest using a foam cushion but I am working on using what I have on hand. I cut 9, 13" squares of the batting and layered them using spray adhesive to keep them together.

I let them set-up for a bit then I took the top of my stool of and traced around it. Then using a pair of crummy scissors I cut out a rough circle.

Now that the "cushion" is finished it is time to focus on the cover. I made a 13" circle template and from that I made a 15" circle template, using this template I traced out the 15" circle on to my fabric of choice and cut it out. The fabric I am using is Michael Miller's Hoopla Dots, it is also the same fabric I used on my craft chair that you might have seen in my Sprocket Pillow post.

The next step is to cut the sides of the cover. The way that I am making this cover means that I have to create a hem for an elastic band. For the width I guessed at how wide I needed it, so I made it 6" wide. I am using leftover fabric from recovering my craft chair, normally I would suggest cutting the fabric selvage to selvage but since I have limited fabric I just used what I could.

I cut 3. 6"x 21" strips just to make sure I had enough fabric, if you are cutting selvage to selvage you would only need 2 strips because most fabric is 36" or wider.

Now to on to the sewing!

Pin your strips right side together and sew them so you get a nice long strip. Next start pinning your sides to the top of the cover. To start fold over 1/2" on one end of your strip, this is so the raw edge will be hidden when you close up the side. Then pin it all the way around the circle making sure right sides are together. When you reach the end make sure you have 1" overlap and trim excess fabric, then finish pinning the extra 1" overlap.

Sew with a 5/8" seam. When you finish sewing the side to the circle you are basically going to top stitch the side seam closed.

Once that is finished it is time to cut the elastic, I used 3/8" elastic but you can use 1/2" if you want. To measured my elastic by wrapping it around the upper portion of the stool legs right underneath the seat and cut it so I had about a 2" overlap. Using a zigzag stitch I stitched the ends of the elastic together.

After trying the unfinished cover on the stool I realized that I may have over estimated how wide to make the sides so I needed to use up the excess. I started by folding over about 1" of fabric and placing the elastic in between to create the hem. I used the edge of my presser foot as a guide and kept my fabric lined up with it and the 1" mark on my machine, I had to stop several times to adjust the fabric because it will bunch up.

Here it is in all it's glory...or not. I realized that after making this one that I need to change my sizes, I probably should have only done a 14" circle and maybe a 4" wide sides. Since it was my first try at making a cover for my stool I think I did good, next time I'll try making it smaller.

Now here it is in action!

Before and After